Saint John’s eagle

Whole Saint John’s eagle, wings, book and base in one piece, without cuts or assembly. Six STL files: 10 cm solid, 16 cm solid and 16 cm with partially hollowed base, each with and without fine supports. Display height includes the base and excludes supports. Two 6 mm drains beneath the hollow base. Clip contacts gradually without pulling feathers. Retain the supported files’ orientation, import in millimetres at 100% and adapt settings to your resin. Layers and drainage digitally checked. Private use, digital files only.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.