Saint Mark’s winged lion

Digital resin-printing files: six STL variants, 10 cm solid, 20 cm solid and 20 cm partially hollow, each with and without supports. The 10 cm sculpture is one piece. At 20 cm the body and base remain one piece; only the two wings detach, with pins and recessed sockets hidden in the feather relief. Eight individual 3MF files are included to print each part separately at 100%; never shrink the combined layout to fit a plate. 20 cm is the assembled height, excluding supports. Hollowing is limited to the base and book, saving about 6% volume, with two 6 mm drains underneath; wings remain solid. Clip fine contacts gradually without pulling on feathers. Dry-fit before gluing. Digital checks only. Adjust exposure to your resin. Private use; no physical figurine shipped.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.