The imperial sleigh

6 STL · 10 and 20 cm · with and without supports
10 cm: solid. 20 cm: solid or partially hollowed. Each variant comes with and without supports. Sculpture heights include the base and exclude supports.

Partial hollowing of the front volume of the 20 cm sleigh, below the reindeer head, saves about 23.4 ml of material (2.1%). Two nominal 6 mm drainage passages open underneath this volume. The base, runners, gifts and small details remain solid.

Geometry and layers checked digitally in ELEGOO SatelLite. Adapt settings to your printer and resin. Clear the openings after removing supports, wash and dry the cavity before final curing. Cut the branches gradually without pulling on details. Fine contacts are provided.

Included files
Traineau-imperial-10cm-plein-sans-supports.stl
Traineau-imperial-10cm-plein-avec-supports.stl
Traineau-imperial-20cm-plein-sans-supports.stl
Traineau-imperial-20cm-plein-avec-supports.stl
Traineau-imperial-20cm-evide-partiel-sans-supports.stl
Traineau-imperial-20cm-evide-partiel-avec-supports.stl