Saint Francis and the wolf of Gubbio

Digital resin-printing files: six STL variants, 10 cm solid, 20 cm solid and 20 cm partially hollow, each with and without supports. The 10 cm scene is one piece. At 20 cm the whole saint and whole wolf detach from the base using four pins and recessed sockets concealed beneath the figures. Eight individual 3MF files let you print parts separately at 100%; do not shrink the combined layout to fit a plate. 20 cm is the assembled height, excluding supports. Only the saint is partly hollow: about 8% less volume for the scene, two 6 mm drains under the robe; wolf and base remain solid. Clean, dry and cure the interior before assembly. Fit the wolf vertically first, then insert the saint along the inclined pins. Dry-fit before gluing. Clip fine contacts gradually without pulling on fingers or paws. Digital checks only. Adjust exposure to your resin. Private use; no physical figurine shipped.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.