Saint Hubert and the stag with the cross

Digital resin-printing files: six STL variants, 10 cm solid, 20 cm solid and 20 cm partially hollow, each with and without supports. The 10 cm scene is one piece. At 20 cm, whole Saint Hubert with the dog and upper terrain, the whole deer and the rock base form three natural parts with recessed joints concealed after assembly. Eight individual 3MF files allow printing each part separately at 100%; do not shrink the combined layout to fit one plate. 20 cm is the assembled height, excluding supports. Only the base is partly hollow: about 0.86% less volume for the complete scene, with two 6 mm drains underneath. Clean, dry and cure the interior before assembly. Insert Saint Hubert first along three inclined 5 mm pins, then the deer vertically on two 2.4 mm pins. Clip external supports near the deer sockets and remove fine contacts gradually. Dry-fit before gluing. Digital checks only. Adjust exposure to your resin. Private use; no physical figurine shipped.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.