SAINT JEAN-MARIE VIANNEY — 6 STL — 10 / 20 CM

6 STL files · 10 and 20 cm · with and without supports

10 cm: solid, with and without supports. 20 cm: solid and partially hollow, each with and without supports. Hollowing saves approximately 15.7 ml of resin (6.3%), with two 6 mm drainage channels under the base. The supported hollow version is tilted by 20°. Dimensions exclude supports.

New hollow variants digitally checked. Import in millimetres at 100%. Keep the supported STL orientation, check layers and adapt settings to your printer and resin. Wash, dry and cure the interior through the openings before closing them. If you have already paid, download the updated pack from your existing order at no additional cost.

The four original solid files are retained. Their small residual detail and suction-cup warnings remain documented; check layers before printing. New supports on the hollow version have fine 0.30–0.36 mm contacts. Cut branches separately while holding the figure, especially near the face, hands and fringes. Do not pull off the entire support structure at once. The channels under the base are long: verify washing, drying and curing throughout the cavity, and keep openings accessible. Choose the solid file if your equipment cannot treat this interior. Private licence: personal use. Do not resell or redistribute files, or sell prints without separate permission.

100 mm: 31.684 × 29.139 × 100 mm
200 mm: 63.368 × 58.277 × 200 mm