Saint Jerome and the lion

Digital resin-printing files: six STL variants, 10 cm solid, 20 cm solid and 20 cm partially hollow, with and without supports. The 10 cm scene is one piece. At 20 cm, the whole saint with his book and rock, the whole lion including its paw, and the base separate at concealed recessed joints. Eight individual 3MF files allow printing each part separately at 100%; do not shrink the combined layout to fit one plate. Assembled height is 20 cm, excluding supports. Only the base is partly hollow, saving about 1.66% of the scene volume, with two 6 mm drains underneath. Clean, dry and cure the interior before assembly. Fit the saint vertically first, then the lion along its inclined pins. Four 5 mm pins with recessed sockets. Dry-fit before gluing. Clip fine contacts gradually without pulling fingers or paws. Digital checks only. Adjust exposure to your resin. Private use; no physical figurine shipped.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.