Saint Martha and the Tarasque

Digital resin-printing files: six STL variants, 10 cm solid, 20 cm solid and 20 cm partially hollow, with and without supports. The 10 cm scene is one piece. At 20 cm, whole Saint Martha with her rope and terrain, the whole Tarasque and the base separate at concealed recessed joints. Eight individual 3MF files allow printing each part separately at 100%; do not shrink the combined layout to fit one plate. 20 cm is the assembled height, excluding supports. Only Saint Martha is partly hollow: about 1.97% less scene volume, with two 6 mm drains beneath her terrain, concealed at the base joint. Clean, dry and cure the interior before assembly. Insert Martha along two inclined pins first, then the Tarasque vertically on two pins. Four 5 mm pins, 7 mm deep, with recessed sockets. Dry-fit before gluing. Clip fine contacts gradually, protecting fingers, rope and fragile details. Digital checks only. Adjust exposure to your resin. Private use; no physical figurine shipped. On the base, clip exterior stems in front of the Tarasque sockets before assembly; the sockets contain no internal supports.

Digitally checked in Elegoo SatelLite. Import in millimetres at 100%. Keep the supplied orientation. Do not automatically add supports to presupported files. Adapt settings to your resin, inspect layers and keep drains clear to wash, dry and cure the interior. Remove supports gradually with small cutters while holding the piece near each contact.

6 mm drains beneath each hollow part. Keep the channels clear to clean and dry the interior. Clip contacts gradually; do not pull on fine details.